Geely Okavango ABS Light Stays On: Wheel Speed Sensor Troubleshooting

I know how frustrating it can be when a warning light just sits there staring at you from the dash. On the Geely Okavango, the ABS warning light coming on and staying on is almost always pointing you toward the wheel speed sensor system. When one of these sensors doesn't send a proper signal, the ABS module knows something is off and keeps the light lit. Let's walk through what's going on and what you should check.

What Causes the ABS Light to Stay On?

The most common culprit is a faulty or contaminated wheel speed sensor, but there are a few other things that can cause the same symptom:

• Wheel speed sensor failure – internal damage or corrosion
• A dirty or damaged reluctor ring – the toothed wheel the sensor reads
• Wiring or connector issues – breaks, chafing, or moisture at the connector
• Low battery voltage or a failing ABS module – less common but possible

Which Sensors and Parts to Check First

Start by reading the fault codes with an OBD-II scanner that supports ABS. The code will tell you which wheel sensor is the problem. If you don't have a scanner, inspect each sensor's connector and wiring for obvious damage, especially along the front wheel wells and rear axle. In my experience, the rear sensors on this model tend to get dirty or damaged more often, so give them extra attention.

Is It Safe to Keep Driving?

You can still drive, and your normal hydraulic brakes will work as always. But keep in mind that the ABS will be disabled, which means on wet or slippery roads your wheels can lock up more easily. That's a real safety concern, so I recommend getting it checked out sooner rather than later. At the very least, drive carefully and avoid panic stops until the issue is fixed.

This material is AI-generated and for informational purposes only — it does not replace an in-person diagnosis by a qualified mechanic.